Used Nissan HR16DE engine: a buyer's guide for importers and workshops
The HR16DE is Nissan's 1.6-litre (1,598 cc) petrol four-cylinder of the Tiida/Versa, Note, Sylphy/Sentra, Sunny/Almera, first Qashqai, Juke (outside Japan), Livina, NV200 and Kicks. It is not the 1.5 HR15DE of most Gulf and Egyptian Sunnys, nor the 1.8 MR18DE of many Tiidas, so order by the code on the block. ENGICOR's published price is US$ 240 per engine, gearbox not included, FOB, Grade A, inside a full container, or from 20 engines (20, 30 or 40) on a new customer's first order.
Wholesale onlyRegular orders are one full container — 90 engines in a 20-ft or 130 in a 40-ft, or with gearboxes 45 + 45 / 65 + 65. New customers can make their first purchase from 20 engines (20, 30 or 40), with gearboxes and consolidated shipping, at list price (LCL freight quoted separately): first-order offer. A second order can start from 45 engines, also at list price. We do not sell single units.
More modelsBeyond the models on this page we hold many more — 488 engine and gearbox families in our warehouse list, always subject to inventory changes. Tell us how many units you need so we can give you the best price: full stock list.
The short answer
What it is. A 1.6-litre (1,598 cc) petrol in-line four, 16-valve DOHC with variable valve timing, built since 2004. Renault uses the same engine as the H4M.
What it is not. The HR15DE (1.5) that many Gulf and Egyptian Sunnys and Tiidas carry, or the MR18DE (1.8) of some Tiidas. Order by the code on the block, not by the car name.
Price. US$ 240 per engine (gearbox not included), FOB Guangzhou, Grade A, inside a full container of 90 (20-ft) or 130 (40-ft) engines. A new customer can start from 20 engines (20, 30 or 40) at list price.
Gearboxes. Two-wheel drive only: conventional automatic US$ 180 or CVT US$ 270, sold untested and as-is. AWD Qashqai and Juke versions need a different unit.
Our check. A manual crankshaft rotation plus photos of every engine. It is not a compression or running test, so plan that test at the workshop before fitting.

Why the HR16DE is a volume engine for Nissan markets
Nissan introduced the 78 mm-bore HR series in September 2004 on the Tiida C11 in Japan, and the 1.6-litre HR16DE then spread across most of its small and compact cars: the Tiida and Versa, the Note, the Bluebird Sylphy and later the Sylphy/Sentra B17, the Sunny/Latio N17, the first Qashqai, the Livina and Grand Livina, the NV200 van and the Kicks.
That spread is what matters to a parts trader: one engine code covers saloons, hatchbacks, a small SUV and a van. It is also the lowest-priced engine in our published catalogue, which makes it a practical way to lower the average price of a mixed container.
Which cars take the HR16DE — and which look the same but do not
Code before car. The same model name carries the HR15DE, HR16DE and MR18DE depending on year and market. Read the code on the block or on the vehicle documents — the engine identification guide shows where to look — or send us the VIN and year and we confirm the code in the quotation.
Gearbox by drive and type. The gearboxes we list for the HR16DE are two-wheel drive only: a conventional automatic (Tiida, Note) or a CVT (Versa, Juke, Kicks, Tiida). An AWD Qashqai or Juke needs a different unit, which we can quote on request.
The HR15DE and MR18DE are supplied on request — tell us the quantities and we quote them by hand. More on the family is on the Nissan MR20 and HR16 page.
| Vehicle | Body / generation | HR16DE fitted? | Watch out for |
|---|---|---|---|
| Nissan Tiida / Versa | C11 (2004–2012) | Yes, 1.6 versions | Many Tiidas carry the HR15DE (1.5) or the MR18DE (1.8) — check the code |
| Nissan Note / Versa Note | E11, E12 | Yes, 1.6 versions | The 1.5 Note E11 is the HR15DE |
| Nissan Bluebird Sylphy | G11 (2005–2018) | Yes, 1.6 versions | 1.5 versions are the HR15DE |
| Nissan Sylphy / Sentra | B17, B18 (2012–) | Yes, 1.6 versions | Other engine sizes use other codes |
| Nissan Sunny / Almera / Latio | N17 (2011–), N18 (2020–) | Yes, 1.6 versions | Most Gulf and Egyptian Sunnys are the 1.5 HR15DE |
| Nissan Versa / Almera (Americas) | N17, N18 (2012–) | Yes | — |
| Nissan Qashqai / Dualis | J10 / NJ10 (2006–2013) | Yes, 1.6 petrol | The 2.0 petrol is the MR20DE; our gearboxes are 2WD only |
| Nissan Juke | F15 (Europe and other markets, 2010–2019) | Yes, 1.6 non-turbo versions | The Japanese-market Juke used the 1.5 HR15DE or the 1.6 MR16DDT turbo, not the HR16DE; AWD needs another gearbox |
| Nissan Livina / Grand Livina | L10, L11 (2006–2019) | Yes, 1.6 versions | 1.5 versions are the HR15DE |
| Nissan NV200 | 2009–2019 | Yes | — |
| Nissan Kicks | P15 (Latin America, Middle East and other markets) | Yes, 1.6 versions | The Indian Kicks (D15) has no HR16DE: it used 1.5 and 1.3 turbo engines; the e-POWER Kicks uses the HR12DE or HR14DDe as a generator |
| Nissan Micra / March | K12, K13 (1.6 versions in some markets) | Yes, 1.6 versions | 1.5 versions are the HR15DE; the current Micra K14 does not use the HR16DE |
HR16DE specifications
Spec sheet: HR16DE spec sheet (PDF). Warehouse list: Nissan HR16DE engine — stock and details.
| HR16DE | |
|---|---|
| Layout | 1.6 L in-line four, petrol, naturally aspirated |
| Displacement / bore × stroke | 1,598 cc · 78.0 × 83.6 mm |
| Valvetrain | DOHC 16-valve, variable valve timing |
| Fuel system | Multi-point electronic fuel injection; later versions use two injectors per cylinder |
| Output | About 103–118 hp (77–88 kW); 158 Nm at 4,000 rpm |
| Renault name | H4M |
| ENGICOR price (engine only, FOB, full container) | US$ 240 |
| Matching gearbox (2WD only, untested, as-is) | Conventional automatic US$ 180 · CVT US$ 270 |
| Availability | On request — confirmed in each quotation |
When a replacement engine is the right call
Workshops replace rather than rebuild a small petrol engine like the HR16DE when the repair bill approaches the price of a sound used unit — typically after overheating has damaged the head or block, after a bearing failure, or when compression is low across several cylinders. That decision belongs to the installer who has the car in front of them; our part is to supply an engine of the right code, Grade A, with a photo record of the exact unit.
If the car also has a gearbox fault, remember that a CVT cannot be judged without driving it under load. That is why our used gearboxes are priced separately and sold untested and as-is.
What to check when the engines arrive
Our check is the same for every engine: cleaning, handling, a manual crankshaft rotation with a tool to confirm the mechanism turns, and photos from every side, delivered to you as an order file — Engine 1, Engine 2 and so on. It is not a compression, leak-down, bench or running test, so it does not prove how an engine will run once installed. You don't need to travel to buy, but you or your representative are welcome to visit for a Guangzhou Inspection Day and review your prepared lot in person, with a visit deposit credited to your order: USD 500 for a visit tied to a first order of 20–40 engines; USD 1,000 for container orders.
On arrival, a simple routine protects you and your customers. The full method is in how to check a used engine before you pay.
| Step | What to do | Why |
|---|---|---|
| 1 | Match each engine to its photos in the order file (Engine 1, Engine 2 …) | Confirms you received the units that were photographed |
| 2 | Read the engine code on every block | Separates HR16DE from HR15DE / MR18DE before you sell |
| 3 | Note what is fitted to each unit (engines come as removed from the vehicle; fittings vary by unit and show in the photos) | So the buyer knows what to transfer from the old engine |
| 4 | Turn the crankshaft by hand | Same check we did before loading |
| 5 | Have the installer run a compression check before fitting | The single most useful test our hand check cannot replace |
Price and how to order
The HR16DE is one of the seventeen published models: US$ 240 per engine, gearbox not included, FOB Guangzhou, Grade A only, inside a full container of 90 (20-ft) or 130 (40-ft) engines, or in the mixed configurations of 45 + 45 and 65 + 65 with used gearboxes. Engine + conventional automatic = US$ 420; engine + CVT = US$ 510. Sea freight, insurance, duty and port charges are on top and depend on your destination.
It mixes easily with the MR20DE (US$ 330) and QR25DE (US$ 450) for X-Trail and Altima customers, or with Toyota and Hyundai-Kia models — a container is priced on the mix of models, not on the brand. See how to plan a container mix and how to buy used engines by the container.
First order: full container, or from 20 engines (20, 30 or 40) on a new customer's first purchase, at list price — see the first-order offer. Contact: WhatsApp (messages only) +971 58 560 8718 · Phone (calls) +971 58 829 2878 · sales@engicor.com.
Sources
- Nissan HR engine — Wikipedia (specifications, years and applications)
- ENGICOR prices and terms: our own published list, recorded monthly in the used engine price index.
Price a container yourself
Build the mix you want in the online quoter — 90 engines in a 20-ft or 130 in a 40-ft, or 45 + 45 / 65 + 65 with gearboxes — and the FOB total reaches your inbox the same minute, at our published per-unit prices, every engine Grade A. Prefer to ask? Tell us the destination country and the models you need and we reply within one business day, usually within hours.
New customer? Your first order can start with 20, 30 or 40 engines, with gearboxes and consolidated shipping available — first purchase only, at list price. See the first-order offer →
Frequently asked
Which cars use the Nissan HR16DE engine?
The 1.6-litre versions of the Tiida/Versa C11, Note E11/E12, Bluebird Sylphy G11, Sylphy/Sentra B17/B18, Sunny/Almera N17/N18, Qashqai J10, Juke F15 (outside Japan), Livina/Grand Livina, NV200, Kicks P15 and Micra/March K12/K13. Renault uses it as the H4M.
Is the HR16DE the same as the HR15DE?
No. Both belong to the HR family and share the 78 mm bore, but the HR15DE is 1.5 litres (78.4 mm stroke) and the HR16DE is 1.6 litres (83.6 mm stroke). Most Gulf and Egyptian Sunnys carry the HR15DE. ENGICOR publishes a price for the HR16DE; the HR15DE is supplied on request.
Can I put an HR16DE in a Tiida that had the MR18DE?
Buy the engine the car left the factory with. The MR18DE is a different 1.8-litre engine; swapping between them is a conversion, not a replacement. We supply the MR18DE on request.
How much does a used HR16DE engine cost wholesale?
US$ 240 per engine at ENGICOR, gearbox not included, FOB Guangzhou, Grade A, inside a full container of 90 or 130 engines; a new customer's first order can start from 20 engines (20, 30 or 40) at the same list price.
Can I buy the HR16DE with its gearbox?
Yes, in the mixed configurations (45 + 45 or 65 + 65) or in a first order: conventional automatic US$ 180 (set US$ 420) or CVT US$ 270 (set US$ 510). Both are two-wheel drive only and sold untested and as-is.
Will the gearbox fit an AWD Qashqai or Juke?
No. The gearboxes we list for the HR16DE are 2WD only; AWD versions need a different unit, which we can quote on request.
Do you test the engines before shipping?
Each engine is cleaned, its crankshaft is turned by hand with a tool, and it is photographed from every side. It is not a compression or running test, so have your installer run a compression check before fitting.
Can I buy one HR16DE engine?
No — we sell wholesale only. A first order starts from 20 engines (20, 30 or 40), and regular orders are a full container that can mix any of the seventeen published models.